Technical resources

Laser Welding Machine Maintenance

Routine care, optics handling, wire feeder and chiller care, and common alarms.

Routine care

  • Clean dust from the cabinet cooling system about once a month and keep the ventilation free.
  • Handle the gun gently. Do not twist, kink or pull the fiber cable; clean the nozzle regularly.
  • Keep the site clean; in dusty production areas, remove dust promptly.
  • Do not open the housing – there are no user-serviceable parts inside. Repairs must be done by trained personnel.

Optics and fiber connector

  • Do lens work in a clean environment and cover any opened chamber.
  • When installing the fiber connector (QBH) in the gun, switch off fans to avoid dust and wipe the connector clean first – even small dust particles can burn the collimating lens.
  • Clean the connector end face with lens paper or an optical swab and a little high-purity anhydrous ethanol or isopropyl alcohol, wiping in a spiral from the centre outwards. Never touch optical surfaces with fingers or ordinary cloth.

Wire feeder

  • Use ordinary solid wire; do not use flux-cored wire.
  • The feed rollers must match the wire diameter – the side marked with your wire size faces outwards – and the wire must sit in the roller groove.
  • Do not bend the wire-feed tube sharply.
  • If the wire sticks out too far at each start, set the retract length 2–4 mm longer than the refill length.

Water-cooled machines (chiller)

  • Keep the water level in the green zone of the tank indicator; use distilled or pure water.
  • After filling, bleed the air from the pump.
  • Change the water about every three months.
  • Frost: drain the tank for transport or long storage; if night temperatures fall below 2 °C, keep the chiller running or use antifreeze, and change back to pure water when the daily average is above 5 °C.
  • In summer, clean the condenser filter about once a month.

Common alarms

Disconnect all power before any troubleshooting. If a problem persists, contact us with the model and a photo of the alarm screen.

  • Temperature alarm: usually the lens temperature – check the lenses and replace a damaged one.
  • Laser alarm: check that the supply voltage is stable (fluctuation normally within 10 %).
  • Gas pressure alarm: check that the gas is on and the pressure is sufficient.
  • Weak laser / wire does not melt: check the protective lens first, then the focusing, reflecting and collimating lenses.
  • Red light is a dot instead of a line (no oscillation): check the scan settings and the gun control cable connections.
  • Abnormal oscillation: check the control cable and avoid interference sources – for example, do not use the machine on the same bench as a TIG welder.

Source: compiled from the operating manuals and product documentation for RUVEN handheld laser welding machines. Always follow the manual supplied with your machine.

Questions about your machine or application?

Send us your question with the model and a photo – we reply via WhatsApp or email.

Chat with us